|
Error Code
|
Description
|
Solution
|
|
154
|
Transverse tilt >20°
|
Hold the instrument without any transverse tilt
|
|
156
|
Transverse tilt > 10°
|
Hold the instrument without any transverse tilt
|
|
160
|
Main tilt direction, angle too high (>45°)
|
Measure angle up to +/- 45°
|
|
162
|
The calibration has not been
accomplished on a leveled
surface and the calibration value
is respecitvely within an ineligible
area.
|
Calibrate the device on an absolute
horizontal leveled surface.
|
|
203
|
Wrong measuring sequence for Pythagoras measurements
|
Measure in correct sequence
|
|
204
|
Calculation error
|
Repeat procedure
|
|
206
|
No endpiece detection
|
Attach the endpiece properly. If error still occurs, replace the endpiece
|
|
217
|
Measuring module error |
|
|
240
|
Data transfer error
|
Repeat procedure
|
|
245
|
2nd button pressed although no
Bluetooth connection exists.
|
Establish Bluetooth connection
|
|
252
|
Temperature too high, above 50°C
|
Cool down the instrument
|
|
253
|
Temperature too low, below 0°C
|
Warm up instrument
|
|
255
|
Receiver signal too low, measuring time too long, distance too long
|
Use target plate, measuring time > 10 sec.
|
|
256
|
Receiver signal too strong
|
Use target plate (white side)
|
|
257
|
Erroneous measurement, too much backlight
|
Use target plate
|
|
260
|
Laser beam was interrupted
|
Repeat measurement
|
|
272-276
|
Measuring module error |
|
|
279
|
Measuring module error |
|
|
285-291
|
Measuring module error |
|
|
297-299
|
Measuring module error |
|
|
402
|
Measuring module error |
|
|
404
|
Measuring module error |
|
|
501-503
|
Measuring module error |
|
|
651
|
Measuring module error |
|
|
801-803
|
Measuring module error |
Category Archives: Uncategorized
Lanyard / Hand Loop Installation
All Leica Disto’s are included with a lanyard / hand-loop to prevent an accidental drop.
To install the lanyard:
1. Locate the 2 small holes near the base on left or right side (some units have these on both sides).
2. Squeeze the small loop at the end of the lanyard and push it into one of the holes. You may need to work it back-and-forth slightly until it comes out the second hole. It is sometimes easier if you can remove the battery door.
3. Loop the entire lanyard through the small loop and pull tight.
Helpful Tips with Disto D5
Helpful tips video on the Leica Disto D5